+86-312-6792432 delia@milestonevalve.com
EnglishEnglish
Home > News

Industry News

Introduction of Common Nonmetallic Materials for Valves

Introduction of Common Nonmetallic Materials for Valves

It is an excellent universal rubber material, suitable for water, gas, oil and grease, gasoline (except gasoline with additives), alcohol and glycol, liquefied petroleum gas, propane and butane, fuel oil and many other media. At the same time, it also has good wear resistance and deformation resista......

View Details
Characteristics of forged stainless steel ball valve

Characteristics of forged stainless steel ball valve

Forged steel stainless steel ball valve is mainly used for long-distance pipeline transportation of oil and natural gas and urban gas pipeline system.

View Details
What Kind of Valve Material Should be Selected for Corrosive Medium

What Kind of Valve Material Should be Selected for Corrosive Medium

Corrosion is one of the most troublesome hazards of chemical equipment. Slight carelessness may damage the equipment, or cause accidents or even disasters. According to the relevant statistics, about 60% of the damage of chemical equipment is caused by corrosion, so the selection of chemical valves ......

View Details
What Should be Paid Attention to When Ball Valve is Applied in Pipeline?

What Should be Paid Attention to When Ball Valve is Applied in Pipeline?

The two main reasons of ball valve damage are: first, the valve switch is not in place; Second, the sealing surface is damaged.

View Details
What are the Common Materials of Valves?

What are the Common Materials of Valves?

Gray cast iron: gray cast iron is suitable for water, steam, air, gas, oil and other media with nominal pressure of PN ≤ 1.0MPa and temperature of - 10 ℃ ~ 200 ℃. The common models of gray cast iron are HT200, HT250, HT300 and ht350.

View Details
What is the Difference Between Swing Check Valve and Lift Check Valve

What is the Difference Between Swing Check Valve and Lift Check Valve

The swing check valve has a pin structure and a gate like disc resting freely against the sloping seat surface. In order to ensure that the valve disc can reach the proper position of the seat surface every time, the valve disc is set in the pin structure, so that the valve disc has enough swing spa......

View Details
<...2223242526>
X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept